Terrasat Rx 1+1, Operation Manual

Page: 74 / 174

5-12
|
Monitor and Control Features and Functions
The MIB-II system group was implemented beginning with version 1.04.
The following commands configure SNMP operation on the Rx 1+1 system:
•
CIT
– Enables or disables the SNMP trap capabilities of the Rx 1+1 system
CIT=1 Enable traps. SNMP must be enabled to generate traps (CIS=1).
CIT=0 Disable traps
CIT?
Displays the current setting of traps
•
CIS
– Enables or disables the SNMP functionality of the Rx 1+1 system
CIS=1 Enable SNMPV1
CIS=0 Disable SNMPV1
CIS? Displays the current setting of SNMP functionality
•
CIH
– Sets the IP address to send traps
CIH=<value> where value is an IP address in dotted decimal notation
CIH? Retrieves the current trap IP address from the Rx 1+1 system
•
CIC
– Sets the SNMP passwords for the Rx 1+1 system
CIC=<public>,<private>,<trap> where public is the public password, private is
the private password, and trap is the trap password.
All three passwords are require when issuing this command. Each password
cannot exceed 16 characters. Passwords may not be read for security purposes.
To configure SNMP using the hand-held terminal (HHT)
1. Connect the HHT to the Rx 1+1 system by using the 19-pin connector.
2. Press the decimal key four times (for example,
. . . .
).
3. Type the password.
The factory default password is
1234
.
4. Press the right arrow key to access the SNMP submenu.
5. Press the 0 key.
6. Press Yes to enable SNMP.
7. Press the Bksp key.
8. Press the 1 key.
9. Press Yes to enable traps.
10. Press the Bksp key.