Section 4 • Repair Procedures
June 2009
Part No. 96316
GS-30 • GS-32 • GS-46
4 - 5
REV D
Gen 4 platform controller
a
function enable switch SW5
b
joystick controller JC1 with thumb
steering rocker SW6
c
horn button BN5
d
machine on incline / turtle button BN6
e
lift function select button BN9
f
drive function select BN8
g
red Emergency Stop button P2
h
yellow arrow
i
platform controls diagnostic display
How to Adjust the Lift Speed
Tip-over hazard. Do not adjust the
lift and/or drive speed higher than
specified in this procedure. Setting
the function speeds greater than
specifications could cause the
machine to tip over resulting in
death or serious injury.
Tip-over hazard. This procedure
must only be performed by a
trained service professional.
Attempting this procedure without
the necessary skills will result in
death or serious injury.
1 Pull out the red Emergency Stop button to the
on position at the ground controls.
2 Push in the red Emergency Stop button to the
off position at the platform controls.
3 Turn the key switch to platform control.
4 At the platform controls, press and hold the lift
function select and horn buttons and pull out
the red Emergency Stop button to the on
position.
Result: The diagnostic display will show "PS."
5 Release the lift function select and horn
buttons.
Result: The diagnostic display will show the
maximum lift speed percentage.
6 Press the lift function select button.
7 Use the steering thumb rocker switch on the
joystick to increase or decrease the maximum
lift speed percentage. Refer to Section 2,
Specifications, for function speeds.
8 Turn the key switch to the off position.
Note: Any change in software settings will not take
effect until the key switch is turned to the off
position.
PLATFORM CONTROLS
Gen 5 platform controller
®
Stop
g
f
e
d
c
a
b
b
f
e
c
i
d
h
g
a
