Section 4 • Repair Procedures
October 2008
Part No. 96316
GS-30 • GS-32 • GS-46
4 - 51
REV C
SCISSOR COMPONENTS
63 Disconnect the number 2A and 2B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
64 Attach a lifting strap from an overhead crane to
the number 2 outer arm at the ground control
side (index #26).
65 Remove the retaining fasteners from the
number 2 center pivot pin (index #11) at the
ground control side.
66 Place a rod through the number 2 center pivot
pin at the ground control side (index #11) and
twist to remove the pin.
67 Remove the retaining fasteners from the
number 2 pivot pin (index #27) at the non-steer
end.
68 Use a soft metal drift to remove the number 2
pivot pin (index #27) from the non-steer end of
the machine. Remove the number 2 outer arm
at the ground control side (index #26) from the
machine.
Crushing hazard. The number 2
outer arm at the ground control
side (index #26) may become
unbalanced and fall if not properly
supported when the pivot pin is
removed.
69 Attach a lifting strap from an overhead crane to
the number 2 outer arm at the battery side
(index #26).
70 Remove the retaining fasteners from the
number 2 center pivot pin (index #11) at the
battery side.
71 Place a rod through the number 2 center pivot
pin at the battery side (index #11) and twist to
remove the pin.
Crushing hazard. The number 2
outer arm (index #26) may
become unbalanced and fall if not
properly supported when the pivot
pin is removed.
72 Remove the number 2 outer arm (index #26)
from the machine.
Crushing hazard. The number 2
outer arm (index #26) may
become unbalanced and fall if not
properly supported when removed
from the machine.
73 Attach a lifting strap from an overhead crane to
the number 2 inner arm (index #25). Raise the
arm to a vertical position.
74 Remove the retaining fasteners from the
number 2 pivot pin at the steer end of the
machine (index #12).
75 Use a soft metal drift to remove the number 2
pivot pin (index #12) from the steer end of the
machine. Remove the number 2 inner arm
(index #25) from the machine.
Crushing hazard. The number 2
inner arm (index #25) may
become unbalanced and fall if not
properly supported when the pivot
pin is removed.
76 Attach a lifting strap from an overhead crane to
the number 1 inner arm (index #14).
77 Raise the number 1 inner arm (index #14)
approximately 2 feet / 60 cm.
78 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x 1.2 m
long block across both sides of the chassis
under the number 1 center pivot pin
(index #13).
79 Lower the scissor arms onto the block that was
placed across the chassis.
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the scissor arms.
80 Attach a lifting strap from an overhead crane to
the lug of the rod end of the lower lift cylinder.
