Voice Gateway 4FXS User Manual
- 71 -
NTP setting command
network> ntp
The command is set by mode of interaction, it does not need any parameter. After
performing the command, CLI will show the on-off state of current NTP client service,
and then inquire users whether to open or close it. Users can choose “disable” or
directly button enter key to get out of the setting, or else, CLI will show the value set
for the address of current NTP server, and inquire users about the server address that
is going to be reset. For instance:
Ntp service is disabled.
Enable Ntpserver? [y/n]: y
Current Ntp IP or domain name is "www.asia.pool.ntp.org".Please
input a new Ntp IP or domain name.
NTPSERVER (Enter to pass):
Ntp IP or domain name is not changed.
Buttoning “Ctrl ＋ C” during setting can give up setting.
Exit command
network> exit [parameter]
Help command
network> help [parameter]
6.2.3 Protocol-related Parameter Setting Command Set
It will immediately go into the protocol-related parameter setting content once input
