55
- Local arming failed
: this type of event is generated when local arming fails. This basically
occurs when attempting to arm the device locally while an input is activated for which the
“
Force
” option is not enabled.
- Remote arming failed
: this type of event is generated when remote arming fails. This
basically occurs when attempting to arm the device remotely while an input is activated for
which the “
Force
” option is not enabled.
- Periodic test report
: this type of event is used for supervising the operation of the device
and it is generated automatically based on the settings below.
Interval of sending
(1…168h): the interval of periodic test report sending. If you change
this setting, make sure to click on the “
Periodic test report
” button found in the
“
Status monitoring
” menu, in order to generate a test report and validate the new
settings. Otherwise, the next test report will still be sent based on the previous setting.
Time of day
(hh:mm): the time of day for periodic test report sending.
- Incoming call from user
: this type of event is generated when the device receives a call
from a user phone number configured in the device. The caller ID (phone number) should be
presented in the call in order to be identified by the device via CLIP service. You can select
user phone numbers for incoming call management and assign an action to them in the
“
Incoming call management
” section.
Phone numbers
: in this section you can select the user phone numbers from which
incomin
g calls will generate an “
incoming call from user
” event, and to which you wish
to assign an action.
Action
: in this section you can configure the action to be performed upon receiving
a call from the selected user phone numbers.
Available options:
None
: no action will be performed.
Arm only
: the device will change its state to armed.
Disarm only
: the device will change its state to disarmed.
Arm/Disarm
: the device will change its state call by call from armed to disarmed,
respectively from disarmed to armed.
Note! Remote arming and disarming is only available at specific arming/disarming
settings! Please check the arming and disarming options in the “General” device
settings
menu.
- Incoming call from unknown number
: this type of event is generated when the device
receives a call from a phone number which is not configured in the device as a user phone
number, or a call received with hidden caller ID.
- Output control by mobile device
(1…4)
: this type of event is generated when the output of
the device is controlled from one of the mobile devices (1 to 4) through the mobile application.
Activating the output will generate a new event, while deactivating will generate a restore.
- Entry delay started
: this type of event is generated when a delayed input is activated while
the system is armed and entry delay starts.
- Exit delay started
: this type of event is generated upon arming the system, when exit delay
starts.
