81
6.2 Remote control and status query by SMS
Controls and status query can be performed by sending commands in SMS to the phone number
of the SIM card installed into the device. The following commands can be used:
SMS Command
Specification
ARM,PWD=
yyyy
,CRQ#
Arming the device (*please read the note below)
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
DISARM,PWD=
yyyy
,CRQ#
Disarming the device (*please read the note below)
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
R1=ON, PWD=
yyyy
, CRQ#
Activating output OUT1 (bistable mode)
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
R1=OFF, PWD=
yyyy
, CRQ#
Deactivating output OUT1
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
R1=ON
x
, PWD=
yyyy
, CRQ#
Activating output OUT1
for “x” (1 to 3600) seconds
(monostable mode)
Substitute parameter “x” with the desired value.
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
R2=ON, PWD=
yyyy
, CRQ#
Activating output OUT2 (bistable mode) - IN4.R2 model only
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
R2=OFF, PWD=
yyyy
, CRQ#
Deactivating output OUT2 - IN4.R2 model only
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
R2=ON
x
, PWD=
yyyy
, CRQ#
Activating output OUT2
for “x” (1 to 3600) seconds
(monostable mode) - IN4.R2 model only
Substitute parameter “x” with the desired value.
If needed, use the CRQ and PWD parameter and substitute
“yyyy” with the device password (see specifications below).
STATUS, PWD=
yyyy
#
Requesting status information (the device will send the states
of inputs and outputs, armed/disarmed status and GSM signal
level in response SMS). If needed, substitute “yyyy” with the
device password (see specification below).
*Arming and disarming will
be refused if the “
Always armed
” or “
Bistable contact
” option is
selected at the “
Arming / Disarming options
” in the “
General
” device settings menu. In these
cases the device cannot be armed and disarmed remotely.
