9
2.9 Installation
Please check the environment before installing the device.
Verify the GSM signal with your mobile phone. It may happen that the signal strength is not
sufficient in the place where you planned to mount the device. If this is the case, you can
reconsider the place of installation before mounting the device.
Do not mount the unit in places where it may be affected by strong electromagnetic
disturbances (e.g. close to electric motors, high voltage, etc.).
Do not mount the unit in wet places or places with a high degree of humidity.
Putting into operation
Disable the voicemail service and SMS notification about missed calls on the
SIM card installed in the device.
The device can handle the SIM card’s PIN code. If you want to use the
PIN code management, configure the SIM card’s PIN code in the programming
software in the “General” device settings menu. Otherwise disable PIN code request
on the SIM card.
Enable both caller identification and caller ID presentation (CLIP) service on the SIM
card at the GSM service provider
(these services might not be enabled by default, please
check). To enable these services, install the SIM card into a mobile phone and call the
customer service of the card’s GSM service provider and enable the services in the menu,
or visit one of the service provider’s personal customer services and ask to enable these
services on the SIM card.
Check the SIM card to be installed correctly into the device.
Check the GSM antenna to be connected correctly to the device.
Check the wires to be connected as instructed in the wiring diagram.
You can power up the device (
12…30V AC/DC). Make sure that the power source is
sufficient for the operation of the device. The nominal current consumption of the device is
120mA, however, it may increase up to 500mA during communication and output control.
If the used power source is not sufficient for the operation of the device, this may cause
malfunctions.
Technical specification
Supply voltage range:
12…30V AC/DC
Nominal current consumption:
120mA
Highest current consumption:
500mA @ 12V DC, 250mA @ 24V DC
Operating temperature:
-
20ºC to +70ºC
2G model:
850/900/1800/1900 MHz
3G model:
900/2100 MHz @UMTS, 900/1800 MHz @GSM
3GA model:
800/850/900/1900/2100 MHz @UMTS
850/900/1800/1900 MHz @GSM
4G model:
900/1800 MHz@GSM/EDGE, B1/B8@WCDMA,
B1/B3/B7/B8/B20/B28A@LTE
4GA model:
B2/B4/B5@WCDMA, B2/B4/B5/B12/B13@LTE
WiFi model:
2.4 GHz, 802.11 b/g/n
Highest load supported on outputs: 1A @ 24VAC/DC
2G model:
Quectel M95
3G model:
Quectel UG95
3GA model:
Quectel UG96
4G model:
Quectel EG91-E
4GA model:
Quectel EG91-NA
Dimensions:
84 x 72 x 32mm
Net weight:
200g
Gross weight (packed):
300g
