TELES VoIP Box BRI Series, Reference Manual

Page: 161 / 226

7 System maintenance and soft-
ware update
VoIPBox DSL / VoIPBox BRI – version 21.0.009 Page 161
The RTP stop message has the following syntax:
rtp stop cr <cr>1 ch <ch>
.
VP module
This module's output shows the controller packets for the
voice connections. This means that the RTCP packets and rel-
evant information also appear.
The following results occur for a new RTP connection:
The following output shows the channel’s state in the com-
pression chip during a startup or change of codec.
The following output shows whether the compression chip
starts sending and receiving packets:
Table 7.15 RTP stop message
Trace Output Description
<cr>
Call reference.
<ch>
The internal media channel used.
a[<controller>]: <VoIPcodecChipType> start(val) ch=<ch> local=<port> remote=<ip
address:port> agg=<bool>
Table 7.16 RTP/RTCP output (VP module)
Trace Output Description
<controller>
Running number for the VoIP controller.
<VoIPcodecChip-
Type>
Stands for the type designation for the compression chips used
(e.g. Ac49x).
<val>
Shows which connection is set up.
<ch>
The internal media channel used.
<port>
RTP port.
<ip address>
Peer's IP address in hexadecimal.
agg=<bool> 1
means an RTP-multiplex connection is used (default
0
).
a[<controller>]: <VoIPcodecChipType>OpenChannelConfiguration ch=<ch> rc=0
a[<controller>]: <VoIPcodecChipType>T38ChannelConfiguration ch=<ch> rc=0
a[<controller>]:<VoIPcodecChipType>ActivateRegularRtpChannelConfiguration ch=<ch> rc=0