TELES VoIP Box BRI Series, Reference Manual

Page: 100 / 226

5 Additional VoIP parameters
VoIPBox DSL / VoIPBox BRI – version 21.0.009 Page 100
5.4 Routing parameters
Table 5.6 Customized parameters: VoIP routing
VoIP Basic Parameters
VoipEnumDomain=<string>
Use this parameter to modify the domain name for the enum query (default is
e164.arpa
).
VoipOadMask=<num>
VoipDadMask=<num>
It is also possible to define the profile by destination or origination number (and not
only by the IP address). That means you can use different parameters not only for dif-
ferent IP addresses, but also for different numbers (for example other codec, Wait-
ForConnect, and so on). For example, you can define a number for the head of the
company, so that her MSN always uses G.711.
It is possible to configure a list of numbers for a total of up to 80 characters per line.
You must define the entry again if you need more numbers. You can also use a wild-
card * at the end of the number to match all calls with OADs or DADs beginning with
the digits entered. Use a comma to separate the numbers.
Example:
VoipDadMask=123, 345*, 567, ....,
VoipDadMask=912, 913*, 914, ....,
Bear in mind that you must enter numbers from specific to global (as for normal rout-
ing in the route.cfg). That means you must enter a profile with more specific numbers
above a profile with more global numbers.
VoIPOwnIpAddress=<ip addr> | RH
If the system is behind a NAT firewall that does not translate H.323 or SIP, the private
IP address (not the NAT firewall's public IP address) is transmitted as own IP address
in the H.323 or SIP messages of the gateway. In this case, the public IP address of the
gateway must be defined or retrieved from the SIP request header. The RH option
only works if this parameter is used in a VoIP profile.
VoipUseEnum=<mode>
Enter yes (default no) to activate an ENUM query to the called number before the call
is set up via VoIP or PSTN. Using a standard DNS query, ENUM changes telephone
numbers into Internet addresses. If a number is found, the call is set up via VoIP. If not,
call setup occurs via PSTN or with another VoIP profile.
NOTE: The query must include country and area codes.
VoipUseIpStack=<mode>
Enter Yes to facilitate direct use of an xDSL or dial-up connection if the corresponding
profile is defined. Default is No.
VoipUseStun=<mode>
Enter yes (default yes) to use the STUN values for the VoIP profile.