Getting Started
3-2
V.3600
Placing a Call
There are three methods for placing a call:
Dialing with a Standard Telephone
1) Lift the telephone receiver. Wait for the dial tone.
2) Dial the number of the remote site.
3) When the answer back tone is heard, immediately press the
TALK/DATA button and hang up the telephone. The modems go
through a connection sequence and establish a data link. If a data
link is not established, return to Step 1.
4) After the link is established, hang up the telephone.
Autodialing from Front Panel
1) If the number to be dialed has not been stored, advance to Main
Menu #6,
CHANGE PHONE NUMBER
.
2) Enter the number by using the NO pushbutton to scroll the menu
and YES to select.
3) After the number is entered, press YES to store the number.
4) Advance the LCD to Main Menu #2,
DIAL STORED
NUMBER
.
5) Select the number to dial and press YES. The number is dialed,
and the modems follow the same process as two telephones.
Autodialing from a Terminal with the AT Commands
To dial a number, for example 555-1212, type
AT
D
555-1212
and
press Enter, or enter
ATDSn
where
n
equals one of the stored telephone
number locations 1-9.
The modem dials the number--either pulse or tone, whichever is
currently in effect--and takes the role of the originate modem.
Refer to the “Dial Commands” section on pa ge5-13 for additional
dialing commands.
Summary of Contents for V.3600 Series
