Telenetics V.3600 Series, User Manual

Page: 211 / 273

Command Index and Defaults
V.3600 E-7
%R
5-30
S53
Disable automatic rate adaption
%R1 S53
Enable automatic rate adaption low BER
%R2 S53
Enable automatic rate adaption medium BER
%R3 S53
Enable automatic rate adaption using high
BER
%T
7-7 -- Transmit test pattern
†
%T=
5-43 -- Followed by a remote configuration security
code, establishes remote configuration
†
%V
5-31 -- Display product revision level
\A
6-10
S63
Maximum block size of 64 characters
\A1 S63
Maximum block size of 128
characters
\A2 S63
Maximum block size of 192
characters
\A3 S63
Maximum block size of 256
characters
\B
6-11
S79
Transmit a break signal
\Bn S79
Sets break length in 20 ms increments,
n
=1-255, default is 35 (700 ms)
\C
6-11
S60
Disable auto-reliable buffer
\C1 S60
Buffer data for 4 seconds or 200
characters
\G
6-8
S54
Disable modem port flow control
\G1 S54
Enable modem port XON/XOFF flow control
\J
6-4
S72
Disable slaved DTE/DCE speed
(constant speed DTE on)
\J1 S72
Enable slaved DTE/DCE speed
(constant speed DTE off)
\J2
-- Enable 230.4 kbps DTE speed
\J3
-- Disable 230.4 kbps DTE speed
Note
The 230.4 kbps DTE speed is available, but the DTE will not
autobaud to 230.4 kbps. With the modem set for 115.2 kbps, enter
AT\J2
to enable the speed, and reset the DTE for 230.4 kbps. When
the modem is set for 230.4 kbps, enter
AT\J3
to disable it if needed.
Reset the DTE for 115.2 kbps.
Table E-1. Synchronous Command Reference (Continued)
Command Page S-Reg Description
†
cannot be executed from remote configuration mode