Telenetics Corporation FT100 S, Installation And Operation Manual

Page: 87 / 134

Control Port Operation
FT 100S 6-9
CONNECTING TO A TERMINAL
To operate the unit with a CRT terminal:
1. Connect the FT 100S control port to a terminal with a stan-
dard PC 25 pin to 9 pin conversion cable. Refer to Table 2-
2 for pin connections.
2. Using the front panel, select terminal operation and the
desired control port baud rate, and enable local character
echo if desired.
Word length is fixed at 8 data bits with 1 stop bit and no parity.
3. Enter a / on the keyboard to display the sign-on screen:
The following illustration shows connection application to a terminal.
Figure 6-2
Terminal Connection
VT 100
115 VAC
60 HZ
14W
CONTROL
PORT 1
NWK
FUS
E
FU
SE
F
U
S
E 3/16
AMP S.B.
250 VAC
FT 100S (rear)
Control port