Telenetics Corporation FT100 S, Installation And Operation Manual

Page: 3 / 134

iii
FCC REQUIREMENTS
This equipment complies with Part 68 of FCC Rules. Please note the following:
When you order service, the telephone company needs to know:
A. The Facility Interface Code:
04DU9-BN (1.544 Mbps superframe format (SF) without line power)
04DU9-DN (1.544 Mbps SF and B8ZS without line power)
04DU9-1KN (1.544 Mbps ANSI ESF without line power)
04DU9-1SN (1.544 Mbps ANSI ESF and B8ZS without line power)
B. The Service Order Code: 6.0N
A signal power affidavit will be required to guarantee encoded analog content and
billing protection unless this unit is used in combination with an XD type device or
no encoded analog signals and billing information are transmitted. A SAMPLE
AFFIDAVIT is attached. For most uses, the second box is appropriate.
C. The USOC Jack Required: RJ48C
In addition, if requested, please inform the telephone company of the make, model
number and FCC registration number, which are on the label.
The telephone company may change technical operations or procedures affecting your equip-
ment. You will be notified of changes in advance to give you ample time to maintain uninter-
rupted telephone service.
If you experience trouble with this telephone equipment, please contact
Telenetics
25111 Arctic Ocean
Lake Forest, California 92630
for information on obtaining service or repairs. The telephone company may ask that you
disconnect this equipment from the network until the problem has been resolved. If your
equipment continues to disrupt the network the telephone company may temporarily discon-
nect service. If this occurs you will be informed of your right to file a complaint with the
FCC.
WARNING
This equipment uses, generates, and can radiate radio frequency energy inter-
fering with radio communications if not installed and used in accordance with the
instruction manual. It has been tested and complies with the limits for a Class A
computing device according to FCC Rules, Part 15. Operation of this equipment
in a residential area may cause interference. If it does, you must correct the cause
of the interference. Shielded cables may be necessary with this unit to ensure
compliance with the Class A limits.
Changes or modifications to this unit not expressly approved by the party respon-
sible for compliance could void the user's authority to operate the equipment.