Telenetics Corporation FT100 S, Installation And Operation Manual

Page: 26 / 134

Hardware Configuration
3-4 FT 100S
Figure 3-3
Strap Application
Grounding
Signal ground is normally separated from chassis ground. If necessary,
signal ground can be connected to chassis ground by moving the strap to
E1.
DTE INTERFACE OPTIONS
Several standard DTE interfaces are available.
Normally, the FT 100S is purchased with the required interface already
installed. However, if application requirements change, the unit can be
reconfigured.
The DTE interface type is selected by
•
installing the appropriate adapter card onto the main printed circuit
board and
•
if required, installing an adapter for converting the DTE connector
on the rear panel.
Installing an Interface Card
The interface adapter card is located on the main printed circuit card as
shown in Figure 3-2.
To remove a card, remove the stand off screws and carefully lift both
ends of the card vertically to unplug the card.
2
=1
1 3
E1
E1