Tektronix WFM700 Series, Service Manual

Page: 34 / 194

Performance Verification
2- 2
WFM700 Series Waveform Monitors Service Manual
Test Equipment Required
Table 2--1 lists the test equipment required to perform all of the performance
verification procedures. Some equipment may not be necessary for your
waveform monitor. The procedures describe the input signal characteristics
necessary to perform the test. Where external test equipment is required, refer to
your test equipment’s user manual for instructions to obtain the correct signal.
Table 2- 1: Test equipment for performance verification
WFM700
Test equipment Requirements Example
1 A HD M
Opt.
DG
HD serial digital video
test signal generator 1080i 59.94 100% color bars
1080i 59.94 10-bit shallow ramp matrix
1080i 59.94 0% flat field
1080i 59.94 75% SMPTE color bars
1080i 59.94 100/0/100/0 color bars
1080i 59.94 100/0/75/0 color bars
1080i 50 100% color bars
1080i 60 100% color bars
720p 59.94 100% color bars
1080i 59.94 100% sweep 1 -- 30 MHz
1080i 59.94 100% flat field
1080i 59.94 20 -- 30 MHz multiburst Tektronix TG2000 with HDVG1
module
D D D D
SD serial digital video
test signal generator 525-format 100% color bars
525-format 10-bit shallow ramp matrix
525-format 0% flat field
525-format 75% color bars
525-format 100% flat field
525 line 60% multiburst Tektronix TG2000 with DVG1
module
D D D
Analog video test sig-
nal generator PAL black
1080i 50 black
1080i 60 black
720p 59.94 black Tektronix TG2000 with AVG1
module
D D D
RF generator 20 MHz to 2.5 GHz
<1 dB level flatness
10 Hz to 100 kHz phase modulation with < 3%
setting error Rohde & Schwarz SMT03 Opt
SM--B2
50
8
N-to-BNC adapter
D D D
Sinewave generator Capable of 0.8 V
p-p
at 6 MHz into a 50
8
load Rohde & Schwarz SMT03 Opt
SM--B2
D
Digital audio generator/
analyzer 35 kHz to 96 kHz sample rate range, jitter
measurement per AES--3 (1997) Rohde & Schwarz UPL06 Opt
B22, B29
D
Test oscilloscope 2 GHz vertical bandwidth Tektronix TDS794
D D D D