Tektronix TLA7000 Series, Installation Manual

Page: 97 / 121

Restoring and Reinstalling Software
NOTE.
The program will not allow you to load fi rmware to an incompatible
module. For example, the program will not load oscilloscope fi rmware to a logic
analyzer module.
The program will load the fi rmware for each module one at a time. The
process may take several minutes per module.
10. When the fi rmware has been loaded for each module, exit the fi rmware loader
program and power down the logic analyzer. You must power down the logic
analyzer to allow the TLA application to start up properly.
11. Remove the logic analyzer module from the mainframe.
12. Locate the big label on the side of the module.
13. Record the fi rmware version that is printed on the label. You will need this
information to see that the fi rmware version matches the label.
14. Reinstall the module in the mainframe and power on the mainframe.
15. After the logic analyzer completes the power-on diagnostics, select System
Properties from the System menu.
16. Click the module tab (for example, LA1).
17. Verify that the fi rmware version for the selected module matches the version
on the label that you recorded in step 13.
18. If the fi rmware versions do not match, power down the mainframe, remove
the module from the mainframe and update the label.
Upgrading Firmware on
TLA7Lx/Mx/Nx/Px/Qx/
Dx/7Ex Modules
Complete the following steps to upgrade the module fi rmware on the TLA7Lx,
TLA7Mx, TLA7Nx, TLA7Px, or TLA7Qx logic analyzer modules and the
TLA7Dx or TLA7Ex oscilloscope modules. These modules require you to install
a jumper on the rear of the module before you can upgrade the
fi rmware.
TLA7000 Series Logic Analyzers Installation Manual 79