Tektronix TekScope THS 710, User Manual

Page: 151 / 197

Appendix B: Factory Setup
B–2
THS 710 & THS 720 User Manual
Control Changed by Factory Setup to
DMM function DC volts
DMM mode – autorange Off
DMM mode – scope on/off Off
Edge trigger coupling DC
Edge trigger level 0.0 V
Edge trigger slope Rising
Edge trigger source Channel 1
Horizontal – main trigger position 50%
Horizontal – Mag Off
Horizontal – time base Main only
Main time base time/div
500
m
s/div
Math waveform function CH1 + CH2
Measure High-Low Setup Histogram
Saved setups No change
Saved waveforms No change
Scope/DMM mode Scope mode
Scope mode – autorange Off
Scope mode – meter on/off On
Trigger holdoff Minimum (495 ns)
Trigger mode Auto
Trigger type Edge
Vertical bandwidth (all channels) Full
Vertical coupling (all channels) DC
Vertical position (all channels) 0 div
Vertical volts/div. (all channels) 100 mV/div