Tektronix TekScope THS 710, User Manual

Page: 134 / 197

THS 710 & THS 720 User Manual A–1
Appendix A: Specifications
This appendix contains the oscilloscope, DMM, and general
specifications for the THS 710 and THS 720 TekScope instruments.
All specifications are guaranteed unless noted “typical.” Specifica-
tions that are marked with the
n
symbol are checked in Appendix D:
Performance Verification.
All specifications apply to both the THS 710 and THS 720 unless
noted otherwise. All specifications assume horizontal MAG is off,
unless noted otherwise. To meet specifications, two conditions must
first be met:
H
The TekScope instrument must have been operating continuously
for ten minutes within the operating temperature range specified.
H
You must perform the Compensate Signal Path operation,
accessible through the utility menu, if the operating temperature
changes by more than 5
°
C.
Oscilloscope Specifications
Acquisition
Acquisition Modes Sample (Normal), Peak detect, Envelope, and Average
Acquisition Rate,
typical Up to 25 waveforms per second (2 channels, sample acquisition
mode, MAG on, no measurements)
Single Sequence Acquisition Mode Acquisition Stops After
Sample, Peak Detect Single acquisition, one or two
channels simultaneously
Average, Envelope N acquisitions, one or two
channels simultaneously, N is
settable from 2 to 256 or
∞