Tektronix PWS4205, Programmer'S Manual

Page: 23 / 90

Command Groups
List Commands List commands con fi gure automatic test sequences for execution on the power
supply. Programming examples for the [SOURce:]LIST:STEP command are
provided in the appendix. (See page B-1, Programming Examples .)
NOTE.
For details on setting values for each list command, refer to the
alphabetical listing of commands.
Table 2-13: List commands
Command Description
[SOURce:]LIST:COUNt Set the number of times a list will execute
(loop)
[SOURce:]LIST:CURRent[:LEVel] Set the current for a list step
[SOURce:]LIST:MODE Set the trigger condition for executing the list
fi le
[SOURce:]LIST:RCL Recall the list fi le saved before from the
register
[SOURce:]LIST:SAVe Save the list fi le into register
[SOURce:]LIST:STEP Set the number of steps for the list operation
[SOURce:]LIST:WIDth Set the step time
[SOURce:]LIST:VOLTage[:LEVel] Set the voltage for a list step
[SOURce:]FUNCtion:MODE Con fi gure for command fi xed mode or list
mode
Digital I/O Commands Digital I/O commands allow you to con fi gure, set, and query the I/O pins on the
rear panel digital input and output lines.
Table 2-14: Digital I/O commands
Header Description
[SOURce:]DIGital:FUNCtion Set rear panel port function
[SOURce:]DIGital:DATA Set/query rear panel port output state
[SOURce:]OUTPut:DFI:SOURce Set output source of DFI
[SOURce:]OUTPut:RI:MODE Set input mode of the remote inhibit (RI)
input pin
Bus Command Group
These commands are used in systems that include a TEK-USB-488 bus adapter
module. The TEK-USB-488 adapter module allows a GPIB controller to
communicate with the power supply.
PWS4205, PWS4305, PWS4323, PWS4602, and PWS4721 Power Supply Programmer Manual 2-11