Technoware EVO DSP PLUS TT 100 KVA, User Manual

Page: 42 / 140

ENGLISH
User’s manual 36 UPS EVO DSP PLUS TT
6 ELECTRICAL INSTALLATION
6.1 Front Side
Each UPS comes equipped with a front door key. After opening the front door, you will see communication area
and several power stages/modules inside.
6.1.1 Power Stage/Module
EVO DSP PLUS TT has an advanced architecture composed of some power stage/modules (from 3 to 6). Each
power stage/module includes a power factor correction Rectifier, a Battery Charger, an Inverter and a Control
Circuits.
There are three DIP SWITCHES (see #2- figure 6.1) for power stage/module ID address setting. In the same
cabinet, each power stage/module ID address MUST be exclusive . Please refer to table 6.1. where the ID
addresses assigned to the power stages/modules are indicated
Figure 6.1 - Power Stage/Module
No. Item Description

FAN
Air enters the power stage/module through the front grills and exhausted through
rear of the module. Please do not block the ventilation vent port.

DIP SWITCHES
There are three DIP SWITCHES for power stage/module address setting. In the
same cabinet, each power stage/module ID MUST be exclusive. Please refer to
table 6.1.
 BATTERY START
BUTTON
When AC input is not existing, use this button to start battery power for UPS.

FAULT LED
ON The power stage/module is in fault condition.
ON/OFF 0.5 sec The power stage/module IDs in conflict.

RUN LED
ON The power stage/module normally works as a SLAVE unit.
ON/OFF 0.5 sec The power stage/module normally works as a MASTER unit.
ON/OFF 0.15 sec The CAN BUS communication doesn’t work.