Technogym Skillmill Console, Technical Service Manual

Page: 63 / 76

7.9 DISASSEMBLING THE
ROLLER BEARINGS (REAR
ZONE)
1. Remove the rear platform on both sides.
2. Remove the rear side guard, on both sides.
3. Use a marker to mark the position of the
bearings.
4. Use a gauge to measure the tensioning de-
vices.
5. Loosen the grub screws on the bearing
stops, on both sides.
6. Loosen the tensioning devices on both
sides.
7. Remove the nuts locking the right bearing.
8. Remove the screws.
9. Remove the flange.
10. Remove the bearing.
To refit the bearing, follow the disassembly instruc -
tions in the reverse order.
Before tightening the grub screws lock-
ing the bearings, check the correct posi-
tion using the tensioning devices.
7.10 DISASSEMBLING THE
ROLLER UNIT
1. Remove the containment flange.
2. Remove the belt from the pulley.
The platform is free to move.
3. Disassemble 13 slats as indicated in para-
graph “7.8.1 Replacing the slats”.
If the bearing bracket must be disassembled,
remove the two upper screws on the rear
beam.
4. Remove the screws.
5. Remove the roller unit.
To refit the roller unit, follow the disassembly in -
structions in the reverse order.
7.11 DISASSEMBLING THE
ROLLER UNIT BEARINGS
1. Remove the containment flange.
2. Remove the belt from the pulley.
The platform is free to move.
3. Disassemble 4 slats as indicated in para-
graph “7.8.1 Replacing the slats”.
4. Remove the bearing.
7.12 DISASSEMBLING THE
ANGLE SENSOR
1. Remove 3 or 4 slats as indicated in para-
graph “7.8.1 Replacing the slats”.
2. Rotate the belt until you can see the angle
sensor board positioned to the right in the
inside of the frame, in the front.
3. Remove the board cover by unscrewing
the two screws.
4. Remove the board from the pin.
Skillmill:
Technical Service Guide - Rev. 2.2
Page 63 e-mail: support@technogym.com