Technogym Skillmill Console, Technical Service Manual

Page: 44 / 76

6.2.3.7 CHECKING THE IP ADDRESS - DEFAULT GATEWAY - NETMASK
Command Notes
Command @RNETPARAM#
Displays the console’s IP address, the default
gateway and the netmask the console is current-
ly using (regardless of whether these have been
assigned in DHCP mode or have been config-
ured as static).
Table 28
6.2.3.8 READING THE WI-FI POWER
Command Notes
Command @RWIFIRSSI# Shows the Wi-fi receiving power.
Table 29
The signal must be above -85dBm (e.g. -80dBm = OK).
6.2.4 CONFIGURING THE REALTIME MONITOR
6.2.4.1 SETTING PARAMETERS
Command Notes
Command @SRTMSOCKET ip_add port#
Sets the IP address and the UDP port where the
realtime monitor is located.
Table 30
The parameter ip_add indicates the IP address where the real-time monitor is located. The param -
eter port indicates the number of the UDP power at which the real-time monitor is located.
6.2.4.2 SETTING THE DATA SEND PERIOD
Command Notes
Command @SRTMPOLLING tsend#
Sets the data send period to the realtime mon -
itor.
Table 31
Skillmill
Technical Service Guide - Rev. 2.2
Page 44 e-mail: support@technogym.com