w w w . t e c h n i c o l o r . c o m / m c s
Page 29
6.2
Setting up Multiple Chassis
For installations requiring more than one COM360 chassis each chassis will need to be assigned a
unique chassis ID. The COM360 chassis has a default setting as chassis one. Chassis identification
is configured via a dipswitch on the backplane circuit board. To access the switch you will need to
remove the rear cover of the COM36 as shown in Figure 10. Take care not to damage the wiring
that connects to the fans on the rear cover.
Figure 10 - COM36 Rear Panel Removal
The dipswitch to set the chassis number is in the top right corner of the COM360 backplane as
shown in Figure 11. Dipswitches are 1-4 from the right to the left looking at the rear of the
COM360. Note: Dipswitch numbers as shown in Figure 11 are added to the photo. They are not
actually labeled on the COM360 chassis.
Figure 11 - Chassis ID Dipswitch
2
2
1
3
2
2
4
2
2