6-2
6. DIAG. TEST OPERATION
EO18-33007
6.1 OUTLINE OF THE DIAG. TEST OPERATION
In system mode the [FEED], [RESTART] and [PAUSE] keys function as described below.
Key Name
Function
[FEED] key
Used to start the system mode as a [PAUSE] key does. Used to select the
parameter mode or to fine adjust the parameters in the negative direction ( - ).
[RESTART] key
Used to select the parameter mode or to fine adjust the parameters in the
positive direction (+)
[PAUSE] key
Used to start the system mode as a [FEED] key does and to select the parameter
mode. Used as an enter key.
■
Type
II
The parameter setting such as feed length fine adjustment or cut/strip position fine adjustment can be
changed while the printer is on-line or printing. Pressing the [PAUSE] key causes the printer to enter
parameter setting mode. Reset mode is provided for this procedure to cancel the steps which follow the
[PAUSE] key without turning the power off.
NOTES:
1. Pressing the [PAUSE] key during printing causes the printer to pause printing and
show the number of remaining media.
2. If the [RESTART] key is released within 3 seconds, the printer will resume printing
because the [RESTART] key is activated.
3. Since the reset is performed when terminating this mode, the printer cancels the
remaining media and returns to on-line mode. This reset will not clear the changed
parameter settings.
Power on
Press the [PAUSE] key. (See NOTE 1.)
Press the [PAUSE] key.
Press the [RESTART] key.
Press the [FEED] key.
Hold down the [RESTART] key for
more than 3 seconds. (See NOTE 2.)
Refer to Section 6.3 Parameter Setting Mode
for the following procedure.
(See NOTE 3.)
Press the [PAUSE] key.
Indicates the number of
remaining media when the
[PAUSE] key is pressed.
Press the [FEED] key
and [RESTART] key
at the same time.
< 1
R E S E T
>
< 2
P A R A M E T E R S E T
>
O N
L I N E
P A
S E
U
5
Summary of Contents for B-880 series
