TEC B-880 series, User Manual, Page: 113 / 180

6-26
6. DIAG. TEST OPERATION EO18-33007
6.3 PARAMETER SETTING MODE
6.3.5 Print Tone Fine Adjustment
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast
forward.
2. A changed print tone value is stored in memory by pressing the [PAUSE] key.
3. Fine adjustment value equals to the sum of the values set by the PC command and system
mode (key operation) and each max. value is
–
10 step. However, the upper limit of the
adjustment value is decided according to the print speed to protect the print head. If the set
value exceeds the following upper limit, it is automatically corrected to the proper value.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key 5 times.
Press the [PAUSE] key .
Continued on Section 6.3.6
Character code selection.
(See NOTE 1.)
Press the [PAUSE] key.
(See NOTE 3.)
Press the [FEED] or
[RESTART] key to fine
adjust the print tone.
(See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
(Thermal transfer printing fine
adjustment)
(Thermal direct printing fine
adjustment)
[FEED] key:
Pressing the [FEED] key one
time is a -1 steps change, up to
-10 steps. (See NOTE 2.)
[RESTART] key: Pressing the [RESTART] key one
time is a +1 steps change, up to
+10 steps. (See NOTE 2.)
[FEED] key:
Pressing the [FEED] key one
time is a -1 steps change, up to
-10 steps. (See NOTE 2.)
[RESTART] key: Pressing the [RESTART] key one
time is a +1 steps change, up to
+10 steps. (See NOTE 2.)
< 1
D I A G N O S T I C V
> 1 . 0 A
T O
E A D J U S T < T >
N + 3
< 2
P A R A M E T E R S E T
>
T O
E A D J U S T < D >
N + 5
3” / sec. +10 step + 10 step
4” / sec. +5 step + 5 step
8” / sec. +2 step + 2 step
Print Speed Thermal Transfer Thermal Direct
Press the [FEED] or
[RESTART] key to fine
adjust the print tone.