TEC B-880 series, User Manual

Page: 147 / 180

6-60
6. DIAG. TEST OPERATION EO18-33007
6.4.2 Process Test Print
In the process test print, the test print is automatically performed under the following conditions.
Parameter setting and print tone fine adjustment value is ignored.
• OPERATION : One label feed, 3-dot slant line print, bar code print, character print
• ISSUE COUNT : 5 labels each
• PRINT SPEED : 8 inches/sec.
• SENSOR : Transmissive sensor (feed gap sensor) or reflective sensor (black
mark sensor)
• RIBBON : Transmissive ribbon
• TYPE : Batch (without cut)
• LABEL LENGTH : 76 mm
• PRINT TONE FINE ADJUSTMENT VALUE :+0
Operating procedure for the test mode is provided below.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key twice.
Press the [RESTART]
key.
Press the [FEED] key
and [RESTART] key
at the same time.
Press the [PAUSE] key.
Press the [PAUSE] key.
Press the [RESTART] key.
[Bar codes are printed on 5 labels.]
After feeding one label, slant
lines (3 dots) are printed on 5
labels.
From
C
on
the next page.
To
A
of the
preceding page.
To
C
of the
preceding page.
To be continued on
B
of the next page.
A U O P R I N T ( R E F L E T C T . )
< 1 D I A G N O S T I C V > 1 . 0 A
< 3 T E S T P R I N T >
P R N T C O N D I T I O N I
6.4 TEST PRINT MODE