TAYO Zontes ZT125-M 2022, Maintenance Manual

Page: 71 / 188

71 / 188
c. Turn over the driving wheel slide plate with Puli beads
and ramp plate as a whole, and then install the distance tube
into the inner hole of the driving wheel slide plate. Then
squeeze the sliding plate and the ramp plate with one hand
(to prevent the spread of the Puli beads from falling), and
hold the exposed distance tube with the other hand to align
the inner hole of the distance tube with the crankshaft, and
then slide the ramp plate, pull beads, and slide The
combination of the disc and the fixed distance cylinder is
assembled as a whole to withstand the φ23.2 × φ40 ×3.25
washer.
d. Place the driven wheel flat on a workbench or a clean
ground, then make the indicating arrow on the V-shaped
drive belt point to the counterclockwise rotation direction,
place the V-shaped drive belt on the outer ring of the driven
wheel, and make a certain distance The driven wheel is 4
～
5cm away. The palms of both hands partially press the clutch
cover of the driven wheel, and the fingers of both hands
buckle the moving plate of the driven wheel while pulling it
upwards while rotating it clockwise. After lifting the moving
plate of the driven wheel by about 10mm (0.4 in), quickly
extend your finger near the side of the V-shaped drive belt to
slide the V-shaped drive belt into the belt groove between
the moving plate of the driven wheel and the fixed plate.
Finally, clamp the middle of the belt with an elastic clip to
prevent the belt from loosening by itself.
Caution: This step requires greater hand strength and
certain operating experience to complete. Insufficient hand
strength or no operating experience may cause injury to
fingers caught by the driven pulley pulley! ! !
e. Pick up the assembled driven wheel and the V-shaped
drive belt as a whole, make the clutch cover of the driven
wheel face outwards, and after the center inner hole of the
driven wheel is aligned with the drive shaft, push the driven
wheel inward into place (on the drive shaft, use When
installing φ14.5 × φ25 ×16, a section of the optical shaft of the
driven wheel bushing is exposed), and the other part of the
V-shaped transmission belt is sleeved on the outer ring of the
exposed crankshaft spline.
f. Put the side of the driving wheel drive disc with the wind
blades facing outwards, align the spline holes in the middle
with the splines on the crankshaft, and then assemble it on
the crankshaft and assemble it in place.
g. Put the φ12.3 × φ40 ×4 washer on the M12×1.25×35
hexagon flange bolt, and then screw the M12×1.25×35
hexagon flange bolt into the crankshaft threaded hole.