TATA Motors Punch 2021, Owner'S Manual

Page: 166 / 238

158
Instructions On How To Use The
Puncture Repair Kit Safely
Use product with original vehicle •
ground tires only.
Only use the Puncture repair Kit with •
tubeless tires.
If used for other than its intended pur- •
pose, the Puncture repair Kit may
cause severe accident or injury due to
the fact that compressed air can act as
an explosive or propellant.
Park your vehicle at the roadside so •
that you do not obstruct the flow of traf-
fic and you are able to use the Punc-
ture repair Kit without being in danger.
Engage the hand brake, even if you •
have parked on a level road, to ensure
that the vehicle will not move.
Do not attempt to remove foreign ob- •
jects like nails or screws penetrating
the tire. Leave them as they are.
Leave the engine running while the •
Puncture repair Kit is in use, but not if
the vehicle is in an enclosed or poorly
ventilated area.
Never leave the Puncture repair Kit un- •
attended while in use.
Do not keep the compressor operating •
for more than 10 minutes otherwise
there is a risk of it over-heating.
Replace the sealant bottle with a new •
one before the expiration date is
reached (see bottle label). In case that
the sealant is expired the functionality
cannot be fully guaranteed. Only use
original Puncture re-pair Kit bottles
which are pressure resistant.
How To Proceed In The Event Of Tyre
Puncture
You can temporarily repair a tire puncture
in two steps.
First pump the tire sealant and air into the
tire (see Step 1). Immediately thereafter,
drive a short distance (3-10 km / 2-6 miles)
in order to distribute the sealant in the tire.
After that, check the tire pressure and
pump more air into the tire if necessary
(see Step 2). Then you can proceed to
drive with caution for a maximum distance
of 200 km (120 miles) and at a maxi-mum
speed of 80 km/h (50 mph).
Inform all other users of the vehicle that
the tire has been temporarily sealed with
the Puncture repair Kit and make them
aware of the special driving conditions to
be observed.
Step 1 :pumping The Tyre Sealant And
Air Into The Tyre
Peel off the decal denoting the maxi- 1.
mum permissible speed (80 km/h | 50
mph) from the casing and attach it to
the edge of the windscreen as shown
on the picture.
Take the hose and power plug with 2.
cable out of the Puncture repair Kit
casing. Unscrew the orange cap of the
bottle connector.
Unscrew the red cap of the sealant 3.
bottle. (Shake sealant bottle well be-
fore use.
WARNING
Need to drain fluid from tire before re-
pair.
EMERGENCY AND BREAKDOWN ASSISTANCE