TallyGenicom Intelliprint 9035, User Manual

Page: 31 / 217

Feb 05
34PPM Laser Printer User Guide 1-17
Installation Procedure
Connecting the Power Cord
1. Connect the power cord to the power cord connector at the back of the printer.
2. Make sure that the power switch has been firmly pushed to the <
{
> position and then
insert the other end of the power cord to the power outlet. If the power cord has an earth
wire, connect it as well.
WARNING! Three power specifications are listed below. The specifications that apply to your
printer depend on its configuration. Connect the power plug only to a properly rated power out-
let. Otherwise, it can cause fire or electric shocks. If in doubt, contact our Printer Support Desk.
Rated voltage: 100 V
Rated frequency: 50/60 Hz
Rated voltage: 110 V
Rated frequency: 60 Hz
Rated voltage: 220 – 240 V
Rated frequency: 50/60 Hz
To prevent fire or electric shock, follow the instruction below based on your machine configura-
tion. If in doubt, contact our Printer Support Desk.
If your machine is a 220 – 240 V model, there is no need to attach a separate earth line since
the earth connection is incorporated in the power line. Plug it into a properly rated outlet.
If your machine is a 100 or 110 V model, use the green earth wire bundled with the power cord,
located at the rear of the machine.
The earth wire must be connected to one of the following conductors:
– Earth terminal of the specified power outlet
– A piece of copper buried in the earth 650 mm or deeper