TAKASAGO HX-S-G2 Series, Instruction Manual

Page: 64 / 240

Useful Function
64
The set value will be initial value to sweep from the target value for sweep operation
.
(V
o
lta
g
e
)
(Elapsed time)
Step 1
SWEEP operation initial value
(e.g. CV 0V)
Number of repetition : First
Step 1 CV value
(e.g. 10V)
(V
ol
ta
ge
)
(Elapsed time)
Step 1
SWEEP
operation initial
value
(e.g. CV 15V)
Number of repetition : First
Step 1 CV value
(e.g. 10V)
How to use sequential operation function
■ Basic Operation
Set initial value of constant voltage (CV) and constant current (CC) at the start of sequential
operation function.
- Constant Voltage (CV) setting value : Any voltage
- Constant Current (CC) setting value : Any current
Please refer to page 28 "Use as constant voltage power supply" for constant voltage (CV) setting.
Please refer to page 30 "Use as constant current power supply" for constant current (CC) setting.
Set value for Over Voltage Protection (OVP) and Over Current Protection (OCP)
applying to the sequential operation function.
Please refer to page41 Over Voltage Protection (OVP) and page43 Over Current Protection for setting
method.
Press the "FUNC." key
"FUNC" lamp will be lit.
Select enable or disable for sequential operation mode.
Select "100" for parameter with VOLTAGE dial and select the desired sequential operation mode with
CURRENT dial.
0 = Sequential operation function is disabled.
1 = Sequential operation function is enabled
(Restart from the beginning after pause of sequential operation)
2
＝
Sequential operation function is enabled
(Resume from the paused point after pause of sequential operation)
→Continued to next
MEMO