TAKASAGO HX-S-G2 Series, Instruction Manual

Page: 17 / 240

Preparation and Connection
17
After wiring, be sure to set the attached output terminal cover.
Connecting Loads
Wiring material to the output terminal by attaching a crimp terminals in the figure below specified, please firmly tighten the
bolt / screw which is included.
30V/60V/120V Type
Load
＋
－
C1
C2
If you want to ground it is done at the
load end.
Do wiring material twisting,
Route as close as much as
possible.
M5 Screw
Output terminal cover
Load
＋
－
C1 C2
If you want to ground it is done at the
load end.
Wiring
material
Do wiring material twisting,
Route as close as much as
possible.
M12 Bolt
M12 Crimping
terminal
Protective tube Insulation lock
Output terminal
cover
400V/500V/1000V Type
Wiring
material
M12 Crimping
terminal
Output Terminal Cover
(Photo is HX-S-0500-12G2)

Twisting wires can minimize the ripple and noise at the load terminal.

The noise level can be lowered to be smaller tha
n the standard value by connecting the C1
and C2 close to the load terminal.
Use C1 and C2 that are small and with high-frequency impedance, and connect the lead
wire cutting it as short as possible.
C1: Electrolytic Capacitor 100 to 1000 μF
C2: Film Capacitor 1 to 10 μF
MEMO