Taarup BIO+ B4000, Operator'S Manual

Page: 56 / 78

56
Operator´s manual BIO bale processor B4000
5.6.4 Error/warning codes
The following table gives an explanation on the error codes:
If an error occurs the control panel will activate an alarm signal for a few seconds. The error
code or restriction that caused the alarm signal can then be read in the screen. The error code
in the screen can be cleared at any time by operating the Clear switch. The following screens
are examples that can show up:
The computerised control system
Error
mes-
sage
Symbol Description Remarks
01 No pulse from net roll during net binding
sequence
02 Net is applied without net binding se-
quence being activated
03 Net knife not under tension
04 No pulse from net actuator May occur at short circuit in the sensor.
06 No pulse from “prestretcher ring drive”
sensor Prestretcher ring not turning.
08 Top section of bale chamber not opened
09 Top section down error Too long time without any signal of top
section having reached lower position
10 Bottom section open / ring up error Too long time without any signal of bot-
tom section having reached upper posi-
tion
12 Cutter down error Cutter has not activated Cutter closed
sensor
13 Top section position” sensor not acti-
vated One of the sensors is faulty
14 Voltage drop Occurs when voltage drops below the
level set in Dealer menu 4
15 Film break is detected Occurs if the machine is fitted with film
break sensors, and the film roll is empty
27 Prestretcher ring outside Safe sector Safe sector sensor not activated
28 Top section not raised Occurs when a function requiring top
section stay open, is activated while top
section is not completely raised
30 Bottom section not raised/ ring not low-
ered Occurs when a function requiring bottom
section is raised, is activated while bottom
section is not completely raised
32 Cutter not closed Occurs when a function requiring film
cutters are close, is activated while cut-
ters are not completely closed