Taarup BIO+ B4000, Operator'S Manual

Page: 34 / 78

34
Operator´s manual BIO bale processor B4000
a
b
a
b c
1
2
3
33cm
4.7 Shear bolts on roller drive
In order to avoid damage to the rollers, two
shear bolts M10 x 50-8.8 act as main safe-
guard (one each in the upper and lower sec-
tion of the baling chamber) in the roller drive.
Both shear bolts are located in the double
chain drive on the left-hand side of the ma-
chine at the front. Should the shear bolts
break, the corresponding hole position can be
found using the reverse lever (set to hexa-
gon).
Spare bolts are stored at forward corners of
the main frame of the machine (b).
4.8 Prestretcher positioning
The control system is automatically monitor-
ing the prestretchers’ positions, refusing top
section to close if there is a risk of damage to
the prestretchers. This is checked by means
of the safe sector sensor (a) and the cam (b).
The positioning sensor (c) controls the exact
position for cutting and parking. The number
of pulses required is checked/set by means
of the control panel.
4.9 Film cutter
The film cutter collects film and cuts it before
bale is discharged. Film end is gripped and
hold ready for wrapping of next bale.
4.9.1 Adjusting open cutter
position
Open cutters completely. Check distance
from end of grip roller to prestretcher roll-
er. End of cutter arm roller should touch
the pre-stretch roller while a
full film roll is
fitted.
Required adjustment is done by means of
screws (1). Slide cutter arm in slotted
holes and re-lock.
Operating the machine