Taarup BIO+ B4000, Operator'S Manual

Page: 48 / 78

48
Operator´s manual BIO bale processor B4000
Select key no. 4 in Process mode:
Press to stop the prestretcher ring in initial position (prestretch-
ers at film cutters). Only applicable during ring movement.
5.2.1.5 Joystick function key
Process Mode in Tool:
Select joystick function group for manual control (in Tool
mode only). Selected functions are shown as a graphic image
on screen.
Joystick function groups:
When Automatic or Manual mode is selected, joystick function
will automatically be set to operate Pick-up up & down/Knives in
& out, since other function groups are not allowed to be operat-
ed when processing bales.
5.2.1.6 Clear switch
Process Mode:
Clears (reset to 00) the error code in the screen.
Edit Mode:
Sets the edited value back to the minimum value allowed for
that parameter.
The computerised control system
5.2.1.7 Enter/OK switch
Process mode:
1. Starts the next process sequence if Manual mode is se-
lected.
2. When an automatic cycle has been interrupted by the stop
key, the system will go the idle mode. When restarted enter-
ing the process mode again, the light next to the Enter switch
will flash to indicate that the interrupted cycle can be contin-
ued by selecting this switch. Entering Tool mode will quit this
‘OK to continue’ function.
3. In Tool mode activating this switch will start a ‘Finish wrap
cycle’. This is a useful function when machine has been
operated by the manual keys, since it is difficult to do cutting
and positioning of the prestretchers simultaneously.
Edit mode:
The key is used as an ‘Enter’ key to confirm the edited value
and to quit editing of the current field. When there is a next
edit field, the edit mode will continue with the next parameter.