Taarup BIO+ B4000, Operator'S Manual

Page: 19 / 78

19
1 Preparing a new machine
1.1 Packing
Remove all kind of packing. Any equipment
stored in the machine should be removed.
Remove the lifting spreader from the top of
the machine prior to any kind of operation of
the top section of the baler chamber.
1.2 Final assembly
Note! Make sure that the machine is
stable during assembly.
1) Check wheel bolts, tension torque 210Nm
(155 lb.ft).
2) Check that any options are correctly fitted.
1.3
Hydraulics
The hydraulics is ready for use.
The working speed of the hydraulic circuits
can be adjusted by means of the set screws
of the lever housings of the valve bank. See
chapter 4.1.3.
1.4 Electronics
Connect system to tractor’s power supply.
Observe! Assure that power supply has
sufficient capacity with stable connections.
Any risk of short breaks in power supply will
cause system to failure. The battery cable
included with the bale processor offers a
steady supply when connected to the battery
terminals. The brown wire shall be connected
to the battery’s positive terminal, the blue
wire to the battery’s negative terminal. The
power supply should under no circumstances
come from the lighter socket!
Fit control panel in tractor cab.
Connect panel to machine’s driver module.
Switch on the screen. The current time is dis-
played.
2 Tractor require-
ments
The machine is connected to the tractor’s
drawbar/hitch.
One single-acting hydraulic outlet with free
return to tank is required. A double-acting
outlet with max 10 bar back pressure can al-
so be used.
The pump capacity required is 35 litres/min at
a pressure of 190bar with engine speed cor-
responding to PTO speed of 540 rpm.
The electronic controls require a steady 12V
power supply. Use the power supply cable
included with the machine connected to the
battery. The solenoids can be operated at
11V power (measured at the solenoid), while
the electronics require min. 11V input power
(measured at the driver module (black box).
Road lights require a standard 7 pin light
plug.
3 Stretch film
Film width: 750mm only
Tackiness: Good, on inner side only
Strength: High flexibility for proper
enclosure at corners and
edges
Film thickness: Must be at least 25 mi-
crometers due to less
thickness when stretched
Max. roller diameter:
235 mm
Preparing a new machine