Taarup BIO+ B4000, Operator'S Manual

Page: 21 / 78

21
It is sometimes necessary to correct the
length of the universal drive shaft due to the
different hitching possibilities and various
tractor types.
To check and correct the length, proceed as
follows:
hitch the bale processor to the tractor
drawbar must be set as described above
pull apart the universal drive shaft and
mount the halves to the tractor and ma-
chine
hold the universal drive shaft halves under
each other
when taking all curves and when driving
straight, ensure that:
– a minimum overlap of b = 200 mm is
guaranteed,
– the universal drive shaft is not sitting
on the block, minimum distance a = 20
mm,
– there is sufficient clearance between
the drawbar and the universal drive shaft
if it is necessary to shorten the length, saw
the same amount off both the sliding and
protective tubes
carefully burr the pipe ends, remove shav-
ings and grease sliding points well
4.1.1.3 Connecting hydraulics
Connect the pressure hose to an outlet
with possibility to adjust the oil flow.
(Yellow cap, connected to the oil filter).
The return hose should be connected to a
free return connection (blue cap).
Operating the machine
Connecting through the double acting outlet
can cause operation problems on the machi-
ne due to high hydraulic backpressure.
4.1.1.4 Connecting computer control system
Connect the driver module to the power
supply of the tractor using the battery ca-
ble provided. Some tractors are standard
equipped with a direct connection from
the battery. This connection might be
used in-stead-of the battery cable includ-
ed with bale processor. Connect the control panels to the driver mod-
ule.
Protect the command panel from rain and
moisture. The driver module (black box)
should under no circumstances be left open,
with the risk of moisture, dust etc. damaging
the electronics.