T-Comfort Comfort Pro S, Mounting And Commissioning Manual

Page: 69 / 200

67
Brief Guide to Initial Configuration Configuration
For the initial configuration you can connect the PC to the Comfort Pro S via the Ethernet port. The TCP/IP
network protocol is used to set up a connection via one of these ports. You can then open the Web console of
the Comfort Pro S and call up the Configurator from there.
N
Note: The Comfort Pro S’s IP address is always 168.99.254 in its factory settings (see
LAN Factory Settings starting on page 78).
Brief Guide to Initial Configuration
Setting up a first connection is quite simple with a standard Windows PC:
1. Connect the PC’s network card with one of the Comfort Pro S.’s LAN ports You can use a crossed or an
uncrossed Ethernet cable to do this.
If the DHCP automatic configuration is functioning, it is possible to continue with step 6.
2. Windows 2000/XP: log on as a user with “Administrator” rights.
3. You will find the IP settings in Windows 2000/XP under Start : Settings : Network connections : Local
Area Connection . Open the dialogue box Local Area Connection Properties , and then the dialogue box
Internet Protocol TC/IP Properties (see figure: Setting the IP address in Windows XP on page 68).
4. Note down the existing settings so that you can restore them after completing the initial configuration.
5. Change the IP Address to 192.168.99.253. Change the subnet mask to 255.255.255.0, confirm with OK
and Close .
6. Start a Web browser and in the address field enter “http://192.168.99.254/”.
The Web console’s log-on page will be displayed. Enter the user name “Administrator” without a password for
the initial configuration.
N
Note: To support your next configuration steps, you should activate the Assistant
mode on the entry page of the Configurator . Please also pay attention to the online
help.