SystemAir Danvent DV-10, User Manual

Page: 102 / 120

9—18
50 Nm
Ø
3,3 mm
9.3.10 Preparation of segments and periphery plates
The periphery plates must be mounted together for preparation of segments and periphery plates. If a
standard bolt is insufficient for bringing together the first and last periphery plates, a threaded rod can be
used as described below.

Position the threaded rod and nut. Tighten until an overlap is achieved.

Tighten the bolt in the overlap.

Replace the threaded rod with clamp bolts.

Tighten all bolts which secure the periphery plate in position.

Use a torque wrench to tighten the bolts.

Any gaps between the inner and outer segments are sealed with sealant.
9.3.11 Installation and adjustment of brush sealing.

Use a 3,3 mm drill bit to drill through every fifth hole.

Install the brush sealing using self ‐ tapping screws.

The outer thread is for protection and must be removed before installation.
Check that the brush sealing fits tightly. The brush sealing must be adjusted if there
is any leakage.
Make sure that the brush seal ‐ ing
is installed with the edge facing up.
Ø 3,3 mm
casing
rotor