SystemAir Danvent DV-10, User Manual

Page: 110 / 120

12—2
12.2 Set ‐ up for Danfoss FC101 for DV ‐ units with AC motors
SETUP IS DONE IN FACTORY BEFORE DELIVERY
To reload Systemair factory settings from the control panel:
0 ‐ 50: LCP Copy: [2]
Systemair factory set ‐ up is based on Danfoss initialization.
14 ‐ 22: Operation mode: [2] Initialisation (Danfoss Initialisation)
Turn power off and on.
Systemair factory set ‐ up:
0 ‐ 01: Language selection:
1 ‐ 03: Torque characteristic: Single fan: [3] Auto ‐ Energy optim.
With twin fan set ‐ up: [1] Variable Torque
1 ‐ 20: Motor Power: According to motor plate / order papers
With twin fan set ‐ up total power must be used
1 ‐ 24: Motor Current: According to motor plate / order papers
With twin fan set ‐ up total current must be used
1 ‐ 25: Motor Nominal Speed: According to motor plate / order papers
1 ‐ 42: Motor Cable Length: 3m
1 ‐ 50: Motor Magnetisation at zero speed.: 0 %
1 ‐ 52: Min. Speed Normal Magnetisation: 10 Hz
1 ‐ 73: Flying Start: [1] Enable
1 ‐ 90: Motor Thermal Protection: [2] Thermistor trip
3 ‐ 15: Reference 1 Source: [2] Analog input AI54
1 ‐ 93: Thermistor Source: [1] Analog input AI53
3 ‐ 03: Maximum Reference: Max. Hz from order papers
3 ‐ 16 + 3 ‐ 17: Reference 2 ‐ and 3 Source: [0] No function
3 ‐ 41: Ramp 1 up: 60 Sec.
3 ‐ 42: Ramp 1 down: 30 Sec.
4 ‐ 19: Max. Output Frequency: 90Hz
4 ‐ 14: Motor Speed High Limit: 90Hz
5 ‐ 12: Terminal 27 Digital input: [0] No operation
5 ‐ 40.0: Function Relay: [3] Drive ready/remote
5 ‐ 40.1: Function Relay: [3] Drive ready/remote
6 ‐ 25: Terminal 54 High Reference: Max. Hz from order papers
14 ‐ 20: Reset Mode: [2] Automatic reset x 2
0 ‐ 50: LCP Copy: [1] All to LCP (Copy of Systemair factory settings to panel)
Connections:
0 ‐ 10V: terminal 54 ‐ 55
Start: terminal 12 ‐ 18
Thermistor: terminal 50 ‐ 53
Drive ready: terminal 1 ‐ 2