Symbol Series 3800, Reference Manual

Page: 54 / 138

4-14
Series 3800 Product Reference Guide
where:
The following message is displayed:
Press <ENTER> when remote is ready. ESC to abort...
3. Do NOT press <ENTER> yet. Set up the Series 384X using the _L.BAT utility as
directed in the section Running _L.BAT.
Running _L.BAT
1. Place the Series 384X in a configuration cradle.
2. Power the terminal on.
3. At a DOS prompt on the 384X, type _L<ENTER> using the keystrokes listed below.
For the 35-key 384X:
<SHF><FUNC><K><L><ENTER>
For the 46-key 384X:
<SHF><FUNC><G><L><ENTER>
4. The terminal boots and displays the message:
Symbol Technologies
NVM Loader 2.X-XX
Connecting to Host
5. Press <ENTER> on the host PC.
6. The batch file runs Program Loader with the communications parameters set to
38,400 bps, 7 data bits, odd parity, and no flow control. The 384X displays the
screen:
SENDHEX is the command
<file name> is the hex file for the application being loaded. There may be other
application hex files which load other software (e.g., STEP version 2.6.0 or
greater, or TelNet Clients 3.0 or greater) to the flash disk.
Note: Be sure to use applications that are flash-disk enabled.
38400 is the baud rate.
[1|2] sets the host communications port the cradle is attached to.