Symantec NetBackup 5230, Installation Manual

Page: 30 / 60

Appliance weight and dimensions:
■
52 pounds (23.58 kg)
■
27.39" (69.59 cm) deep
■
17.24" (43.8 cm) wide
■
3.45" (8.76 cm) high
The rack rails that are provided for the appliance are extensible to 30” (752mm).
This distance is the maximum depth that is allowed between rack posts. If the
distance between rack posts is longer than 30” (752mm) the rails and the appliance
cannot be properly installed. The width of the appliance is 19” (482.6mm).
Make sure that the installation location has extra space for the following:
■
Front bezels and rack handles
■
Rear panel power supply latches
■
Rear panel cable connectors
Removing the protective film from the storage shelf
The Symantec Storage Shelf ships with a clear, protective film on the top, bottom,
and sides of the chassis. You need to remove the film before you install the storage
shelf into the rack. The storage shelf does not install properly if the film is not
removed.
The front panel and the rear panel do not include any film.
To remove the protective film
Warning:
Make sure that another person is available to help lift the storage shelf.
1 Peel the protective film from the top of the storage shelf.
2 Lift up one end of the storage shelf and peel the film from the bottom of the
chassis.
3 When approximately half of the film is removed, lift the other end of the
storage shelf and remove the remaining film.
4 Peel the film from the sides of the storage shelf.
5 Discard all of the film.
See “Installing the Symantec Storage Shelf guide rails” on page 31.
Installing hardware into racks
Removing the protective film from the storage shelf
30