SWASH SFF1000CSA series, Technical Education

Page: 29 / 50

COMPONENT ACCESS
SWASH™ Clothing Care System
n
3-9
Removing the Clips & Roller Assembly
5. Set SWASH™ system upright. Using a #15 TORX driver,
remove the two (2) screws securing the top door cover as
illustrated in Figure 4. Remove cover to expose the upper
slide assembly.
Figure 4
6. Separate the upper slide from the door frame . Using a #1
Phillips screwdriver, remove the three (3) bolts and nuts
securing the upper door to the slide assembly. See Figure 4.
Door assembly can now be removed from SWASH™ system.
Figure 4
Removing the Clips & Roller Assembly
1. First, perform procedure on page 3-8, “Removing the Door
Assembly” prior to performing the following steps.
2. Using a #2 Phillips screwdriver, remove the door knob
from door assembly.
3. Remove door cover from door frame. The door cover is
attached to the frame by six (6) clips (see Figure 1). Slowly
pull the door cover from the frame 1 clip at a time starting
from the bottom and working to the top.
Figures 1 & 2
4. Remove Clip and Roller Assembly. Using a #2 Phillips
screwdriver, remove the four (4) screws (2 on each side)
securing the clips & roller assembly to the upper door
frame. See Figure 3.
Figure 3
Phillips Screws
Phillips Screws
(each side)