3-6
n
SWASH™ Clothing Care System
COMPONENT ACCESS
Removing the User Interface
1.
First, perform procedure on page 3-4, “Removing the Rear
Panel” prior to performing the following steps.
2.
Next, perform procedure on page 3-5, “Removing Top
Cover and Control Housing.
3.
Slide open door.
4.
Disconnect harness from UI PCB. See Figure 1.
5.
Using a 1/4” nut driver, remove the two (2) screws
securing the User Interface to the control bracket as
illustrated in Figure 1. Pull UI Assembly forward over the
door switch and remove from unit.
Figure 1 - User Interface
Removing UI and Dispensing System
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
UI Harness
Removing the Dispensing System
1.
First, perform procedure on page 3-4, “Removing the Rear
Panel” prior to performing the following steps.
2.
Next, perform procedure on page 3-6, “Removing Top
Cover and Control Housing.
3.
Disconnect hose from Dispensing System.
4.
Disconnect harness from Dispensing System micro-switch.
See Figure 1.
5.
Using a 1/4” nut driver, remove the two (2) screws
securing the Dispensing System to the control bracket as
illustrated in Figure 1. Remove Dispensing System from the
unit.
Figure 1 - Dispensing System
Switch Harness
Pump Hose
Summary of Contents for SFF1000CSA series
