SWASH SFF1000CSA series, Technical Education

Page: 27 / 50

COMPONENT ACCESS
SWASH™ Clothing Care System
n
3-7
Removing the Pump Assembly
1. First, perform procedure on page 3-4, “Removing the Rear
Panel” prior to performing the following steps.
2. Next, perform procedure on page 3-5, “Removing Top
Cover and Control Housing.
3. Disconnect hose from Pump Assembly (see Figure 1).
4. Disconnect hoses from “T” fitting (see Figure 1).
5. Disconnect harness from Pump Assembly (see Figure 1).
6. Using a 1/4” nut driver, remove the four (4) screws
securing the Pump Assembly to the control bracket (see
Figure 1). Remove Pump Assembly from the unit.
Figure 1 - Pump Assembly
Removing Pump, ACU, and Thermistor
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Removing the Appliance Control Unit (ACU)
1. First, perform procedure on page 3-4, “Removing the Rear
Panel” prior to performing the following steps.
2. Next, perform procedure on page 3-5, “Removing Top
Cover and Control Housing.
3. Disconnect the four (4) harnesses from the Appliance
Control Unit (ACU).
4. Using a 1/4” nut driver, remove the one (1) screw securing
the ACU to the control bracket (see Figure 1). Remove
ACU from unit.
Figure 1 - ACU
Removing the Thermistor
1. First, perform procedure on page 3-4, “Removing the Rear
Panel” prior to performing the following steps.
2. Next, perform procedure on page 3-5, “Removing Top
Cover and Control Housing.
3. Disconnect the two (2) wires going to the Thermistor
Assembly (see Figure 1).
4. Using a 1/4” nut driver, remove the two (2) screws
securing the Thermistor to the control bracket (see Figure
1). Remove Thermistor from unit.
Figure 1 - Thermistor
Thermistor
Wires
Pump Hose
Pump Harness
“T” Fitting Hoses