COMPONENT ACCESS
SWASH™ Clothing Care System
n
3-11
Removing Base Components (continued)
8.
Disconnect the blower and heater connectors (see Figure 4).
9.
Using a 1/4 nut driver, remove the screw securing the
ground wire coming from the blower motor (see Figure 4).
10.
Using a 1/4” nut driver, remove the seven (7) screws
securing the blower/heater assembly to the unit (see
Figure 4).
Blower
Connector
Heater
Connector
GND Screw
11.
To remove the heater from the blower/heater
assembly, use a 1/4” nut driver to remove the two
screws securing the heater to the blower housing (see
Figure 5 below).
12.
Remove heater assembly from blower housing. The
heater assembly contains the heater coil, thermal
cutoff, and high limit thermostat. (See Figure 6.)
Figure 6
IMPORTANT: The fan motor and blower wheel cannot be
replaced individually. The fan motor, blower wheel, and
blower housing must be replaced as an assembly.
Figure 5
Heater Screws (2)
Heater Assembly
Figure 4
Fan Motor
Blower Wheel
Summary of Contents for SFF1000CSA series
