3-8
n
SWASH™ Clothing Care System
COMPONENT ACCESS
Removing the Door Assembly
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Removing the Door Assembly
1.
Unplug the SWASH™ Clothing Care System.
2.
Slide open the door assembly as far as possible (see
Figure 1).
Figure 1
3.
Lay SWASH™ system on its side to access the bottom of
the door assembly (see Figure 2).
4. Separate the lower slide from the door frame
. Using a
#2 Phillips screwdriver, remove the two (2) ‘side-mounted’
screws and using a #15 TORX driver, remove the four (4)
‘bottom-mounted’ screws as illustrated in Figure 2.
Figure 2
NOTE:
When reassembling the door frame to the lower slide,
be sure to place the tab of the lower slide assembly into the
slot located under the door frame as shown in Figure 3.
Figure 3
Phillips Screws
TORX Screws
Frame Slot
Slide Tab
continued . . .
Summary of Contents for SFF1000CSA series
