Suzuki SWIFT 2022 Series, Owner'S Manual

Page: 194 / 622

3-10
OPERATING YOUR VEHICLE
80SS5-01E
• If the battery of the remote controller is
becoming discharged, the correspond-
ing message will appear in the informa-
tion display when you press the engine
switch to change the ignition mode to
ON. Refer to “Information display” in
“BEFORE DRIVING” section for details.
For details on replacing the battery, refer
to “Keyless push start system remote
controller / keyless entry system trans-
mitter (if equipped)” in “BEFORE DRIV-
ING” section.
REMOTE CONTROLLER OUTSIDE
warning
When either of the conditions described
below is met, the system causes a
REMOTE CONTROLLER OUTSIDE warn-
ing by sounding the interior and exterior
buzzers. At the same time, the immobi-
lizer/keyless push start system warning
light comes on and the master warning
indicator light (Instrument cluster Type B or
C) blinks.
• Any door is opened and then closed while
the remote controller is not inside the vehi-
cle and the engine is running or the igni-
tion mode has been changed to ACC or
ON by pressing the engine switch.
• The remote controller is not inside the
vehicle when you attempt to start the
engine after changing the ignition mode
to ACC or ON by pressing the engine
switch.
52RM30230
(1) Immobilizer/keyless push start sys-
tem warning light (blinks)
(2) Master warning indicator light (blinks)
(Instrument cluster Type B or C)
NOTE:
• If the warning is given, relocate the
remote controller as soon as possible.
• Any attempt to start the engine will fail
while the warning is active. The mes-
sage appearing in the information dis-
play in the instrument cluster will also
indicate this condition. Refer to “Informa-
tion display” in “BEFORE DRIVING” sec-
tion for details.
• Normally, the immobilizer/keyless push
start system warning light should go out
and the master warning indicator light
should stop blinking shortly after the
remote controller is brought back inside
the vehicle. If they remain lit and blinking,
change the ignition mode to LOCK (OFF)
by pressing the engine switch and then
perform the engine starting operation.
Refer to “Starting / stopping engine (vehi-
cle with keyless push start system) (if
equipped)” in this section.
• Always keep the remote controller with
you as the driver.
Interior workable area for keyless
push start system
68PH00306
(1) Interior workable area
The interior workable area is defined as all
the interior spaces except for the space
above the instrument panel or in the lug-
gage compartment.
(1)
(2)
EXAMPLE
(1)