Suzuki SWIFT 2022 Series, Owner'S Manual

Page: 264 / 622

3-80
OPERATING YOUR VEHICLE
80SS5-01E
Situation where the system may not
activate properly
Under the following situation, the system
may not activate.
• Right after lane changing
If the dual sensor cannot detect partition
lines except for the above situation, the
system may also not activate. Refer to “Sit-
uations where the dual sensor may not
activate properly” in this section for details.
High beam assist
Depending on the forward brightness con-
ditions of the lights from the vehicle in front
of you and street lights, high beam
(upward) and low beam (downward) of
headlights will be switched automatically.
52R40460
When the following conditions are met, the
high beam assist system is activated.
When the system is activated, the high
beam assist indicator light (green) comes
on.
• The ignition switch is turned to “ON”
position or the engine switch is pressed
to change the ignition mode to ON
• The headlights are turned on when it
becomes dark outside the vehicle
• The lighting switch is in “AUTO” position
• The lighting control lever is pushed for-
ward
To cancel the function, pull the lever to the
original position.
52RM20740
Under the any of following situations, the
low beam turns on.
• When vehicle speed is approximately 35
km/h (21.7 mph) or under
• When the front of the vehicle is bright
• When the vehicle in front of you turned
on the lights
• There are many street lamps in front of
you
Under the all of the following conditions
are met, the high beams (main beams)
turn on.
• When vehicle speed is approximately 40
km/h (24.9 mph) or over
• When the front of the vehicle is dark
• When the vehicle in front of you is driv-
ing without lights
• There is few street lamps in front of you
NOTE:
• Light vehicle such as a bicycle might not
detected.
• In sudden acceleration, high beam
assist might not operate for a few sec-
onds, even if vehicle speed exceeds
40km/h (24.9 mph).
WARNING
• High beam assist has limits and
may not function properly depend-
ing on the surrounding environ-
ment.
Always drive in a safe manner,
switch manually to the low beams
and high beams (main beams), if
necessary.
• Switching of the low beams and
high beams (main beams) might
not match the feeling of the driver.