6-46
Rear axle nut tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is
shown on the table below. When
replacing a burned out bulb, always
use the exact same wattage rating.
Using other than the specified rating
can result in overloading the electrical
system or premature failure of a bulb.
WARNING
Failure to adjust the drive chain
and failure to torque bolts and
nuts properly could lead to an
accident.
• After installing the rear wheel,
adjust the drive chain as
described in the DRIVE CHAIN
ADJUSTMENT section.
• Torque bolts and nuts to the
proper specifications. If you are
not sure of the proper proce-
dure, have your authorized
Suzuki dealer or a qualified
mechanic do this.
WARNING
Failure to extend brake pads after
installing the wheel can cause
poor braking performance and
may result in an accident.
Before riding, “pump” the brake
pedal repeatedly until brake pads
are pressed against the brake
disks and proper pedal stroke and
firm feel are restored. Also check
that the wheel rotates freely.
NOTICE
Failure to use a light bulb with the
correct wattage rating can over-
load the electrical system of your
motorcycle or cause the bulb to
burn out sooner.
Use only the light bulbs shown in
the chart as replacement bulbs.
Headlight
12V 55W (H11)
... Low beam
12V 65W (H9)
... High beam
Turn signal light
12V 21W × 4
Position light
12V 5W × 2
License plate light
12V 5W
Summary of Contents for GSX-R1000/A
