8-3
79MH0-74E
To Raise the Vehicle with a Garage
Jack
• Apply the garage jack to one of the
points indicated below.
• Always support the raised vehicle with
jack stands (commercially available) at
the points indicated below.
Front jacking point for garage jack (1)
79MH0758
Rear jacking point for garage jack (2)
79MM08002
Application point for jack stand (3)
or two-column lift
61MM0B103
WARNING
• Use the jack only to change wheels
on level, hard ground.
• Never jack up the vehicle on an
inclined surface.
• Never raise the vehicle with the
jack in a location other than the
specified jacking point (shown in
the illustration) near the wheel to
be changed.
• Make sure that the jack is raised at
least 50 mm (2 inch) before it con-
tacts the flange. Use of the jack
when it is within 50 mm (2 inch) of
being fully collapsed may result in
failure of the jack.
• Never get under the vehicle when it
is supported by the jack.
• Never run the engine when the
vehicle is supported by the jack
and never allow passengers to
remain in the vehicle.
(1)
EXAMPLE
(2)
EXAMPLE
(3)
(3)
EXAMPLE
